Plumbing and water treatment companies are often faced with complaints pertaining to bad odors emanating from the water heaters. These unpleasant smells are commonly described as ”water smells like rotten eggs”.
The odor issues can cause numerous problems for the inhabitants, and often becomes a topic of conversation when guests are around. Today, we present the optimal, most efficient, method to get rid of this Sulfur smell.
首先，值得注意的是 sulfur smell in water can be caused by a number of different reactions.
If the odor is present only in your hot water, it is usually created by the presence of sulphate-reducing bacteria in your hot water tank. In some cases, it can also be caused by a chemical reaction between your magnesium anode and the hot water.
If the odor is present in both hot and cold water, the problem usually stems from the presence of hydrogen sulfide gas in the water underground. Since it’s coming from your water supply, this problem is the most expensive to fix.
Now that you know the causes of these nauseating smells, let’s solve the problem!
Generally seen living in a low-oxygen environment such as water heaters, deep wells, as well as in the plumbing network, this sulfate reducing bacteria take their energy from sulfur. Since they usually proliferate in hot water, it is standard for the 蛋臭味 在面对这些环境时进行放大。
一种 临时解决方案 would be to do a concentrated chlorination treatment, which involves adding a predetermined amount of chlorine to your well and circulating the water through all your ducts. Once the smell of chlorine is noticeable throughout your home, simply let the water run until the smell disappears.
It is not recommended to use or consume this water for 24 hours after treatment, which makes this solution much less convenient. In addition, since this is a temporary solution, keep in mind that odors will be back in 1 or 2 months.
Permanent Solution: Corro-Protec Powered Anode
Since 2012, there’s a new way to solve this sulfur smell and it’s guaranteed to work. By creating an environment in the water heater where the sulphate-reducing bacterium is not able to survive, the Corro-Protec阳极 will be able to stop that sulfur smell in only 24 hours.
In addition to being guaranteed for 20 years, the Corro-Protec only takes 15 minutes to install. Today, more than 55,000 households have adopted this solution and solved their hot water odor problems for good.
每个热水器都配有一个 镁阳极 rod in order to temporarily limit corrosion within the tank. In most cases, the smell of sulfur will be caused by high magnesium content water that comes into contact with the original anode already present within the water heater.
If the odor issue comes from the reaction between the magnesium anode and your water, several options are available to you. However, it is important to know that these options are not all good in the long run.
It would be possible to eliminate these odors by completely removing the magnesium anode from the tank. However, doing so is very dangerous for the water heater because it will then be without its protection against rust. The weakest and most exposed places will then rust faster forcing you to change your tank after only a few years.
It is also possible to replace the magnesium with an aluminum anode. Water will no longer have a poor chemical reaction while supported by the new anode, and odors should completely disappear.
However, even though aluminum anodes are cheaper than magnesium anodes and last longer, the main issue is that as the anode dissolves, debris tends to harden and sink to the bottom of the reservoir. This can potentially end up in your faucets and cause breakage. In addition, some scientific research raises concern regarding aluminum residues found in water which could have adverse effects on 人民健康.
Install an Powered Anode
In conclusion, a powered anode is the ideal solution to these problems, because in addition to eliminating this rotten egg smell in a few hours, these anodes are made from insoluble titanium, which limits their debris.
In addition, this technology requires no maintenance and is good for several years. Corro-Protec阳极 are easy to install in your existing tank and will fix the problem, no matter what the cause of the odors, in just a few hours.
在9个月前放入新的热水炉后，我们的房屋在热水中有一段时间出现“烂鸡蛋”的气味。经过数次尝试以震撼我们的水并向四周征求建议后，我们上网浏览并找到 Corro-Protec阳极 在YouTube演示中我们曾经花过的最好的$100.00。阳极棒易于安装，气味立即消失了90%。早上洗完澡后完全没了，所以我很开心！！！